Home > Products > Aupart Driveline Spacers

Aupart Driveline Spacers  

Tail Shaft Spacer

Is your Manual ML Triton (06-on) suffering from significant driveline vibration following a suspension lift? This is most likely due to the fact that the Manual ML Triton has a two piece drive shaft with centre bearing. Your mate in the Auto ML Tridon, with the same lift, will not have the same issues because the Auto versions have a single piece drive shaft. The Aupart 13.25mm Diff Spacer is fitted between the rear drive shaft and the diff, lowering the bearing by 5-8mm, and compensates for the absence of a slip joint in the drive shaft prolonging the life of the Centre Bearing. In extreme cases it will not fix vibration issues.  
Part NumberApplicationSuits Lift
AX0374 MITSUBISHI TRITON ML-MN 2"+

 

Transmission Spacers

The Aupart Transmission Spacer Kits provide a fix to aid in controlling the driveline vibration and noise after a lift is installed.
AX0323 - Nissan Patrol
The Patrol transmission spacer plates fit neatly between the transmission plate and the chassis, and works by spacing down the driveline thus reducing driveline angle affected with the lift. The Aupart kit includes 4 precision cut 6mm spacer plates, and fitting hardware to suit (extended bolts). The four spacers allow you to run either 6mm or 12mm spacers depending upon your lift.
AX0420 - Ford Ranger/Mazda BT50
The Ranger/BT50 centre bearing spacers are applied to the u shaped cage that holds the centre bearing into position, and effectively lowers the cage, and centre bearing, down to take the angle out of the pinion. The kit is supplied complete with 12 x 3.9mm spacer washers, to suit for the spacing requirement identified (from 3.9mm to 23.7mm), depending upon your lift. All lift kits quoted for Ford Ranger/Mazda BT50 should include a Centre Bearing Spacer Kit, because driveline vibration can be experienced even with the smallest lifts.

 

Part NumberApplicationSpacerSuits Lift
AX0323 NISSAN PATROL GQ-GU TRANSMISSION SPACER KIT 2"+
AX0420 FORD PX RANGER / MAZDA BT50 (Gen2) CENTRE BEARING SPACER KIT 2"+